Figuring out how to supplant your dryer belt can assist with setting aside you cash. You don’t need to be a do-it-yourselfer to put on another dryer belt. It is a seriously considered normal fix, and you’ll just need a couple of devices to make it happen. You’ll require: Phillips screwdriver, clay blade, 5/16 attachment or nut driver, and a little holder for the screws. This article will clear up how for supplant a dryer belt, for the models with the build up channel on top.

Assuming your dryer has the build up channel on the top, here is the method for supplanting the belt. The primary thing you ought to continuously fix up any apparatus is turn off the unit from power. Not doing so could bring about serious harms to yourself and your machine. Slide out your build up channel, and eliminate the two screws that are uncovered. Then, take your clay blade and slide it under the highest point of the dryer, spring up the top by lifting up on the left and right corners on the facade of the dryer. Then, at that point, lift up the top, flip it back, and prop it on a wall if possible.

Now that within the dryer is uncovered, you should eliminate the front board to get to the belt. There are two screws you really want to eliminate to remove the front board, and they are situated on the left and just inside corners wood veneer dryer machine. When the screws are taken out, you can take off the front of the dryer. Once in a while you’ll have to eliminate the entryway change to eliminate the front totally.

Presently you can eliminate your old belt. You might require someone else to assist you with holding up the drum for this part. Take out your new belt, and spot it over the drum with the sections contacting the drum, ensure it isn’t contorted any other way it will simply tumble off once you start your machine. Then, you’ll have to get under the drum where the engine and pulley are found. The belt should go through the pulley, and connected to the engine shaft. On the off chance that this was done accurately, the pulley will apply strain to the belt.

Presently you’re finished with the establishment of your new dryer belt. Also, to complete you’ll have to re-gather your dryer. At the point when you set back the front board of your machine, ensure the tabs on the base are agreed with the actual board, it ought to simply fit properly. Supplant the screws within both ways corners, then flip the highest point of the dryer back down. This ought to likewise adjust back properly. Then, at that point, just set back the screws on the top where the build up channel goes, and slide the build up trap in. The last thing is to connect your dryer, and you’ll be ready to take on the world.